Page Comparison

OpenSim uses the standard engineering coordinate system of X forward (Red), Y up (Green), Z right (Blue). This convention is confirmed using the right-hand rule.

When collecting data to input into OpenSim it is important to note the coordinate system of the collection system. Every set of (x, y, z) coordinates obtained from a motion capture system is given relative to some coordinate system. Typically, this coordinate system is called the laboratory coordinate system, laboratory coordinates, or Ground.

Typically, motion capture systems use laboratory coordinates such that X is forward, Y is left, and Z is up. Collecting any data in this coordinate system would require a 90 degree rotation about the X axis before using in OpenSim.

Before inputting any data from motion capture into OpenSim, it is your responsibility to ensure that all (x, y, z) values have been transformed from the laboratory coordinate system to the model coordinate system used in OpenSim.

In the figure to the left, marker data (blue spheres) and ground reaction forces (green arrows) have been transformed from the motion capture coordinate system to the OpenSim coordinate system. This required a 90-degree rotation and all distances being converted to meters.

To perform the rotation, you could use conversion packages found here or use the rotation method in the OpenSim GUI.

To transform Data in the GUI, open your experimental markers (.trc file) or forces (.mot file) in the GUI. Then right click on the on subject name and select Transform. A Pane will open that will all for the rotation data. Rotate your data and then save to a new file.